HomeHaven
← All articles

November 7, 2026 · HomeHaven

Manufactured Home Electrical Systems: What Buyers Should Know Before You Sign

HomeHaven is a free manufactured home matchmaker — not a lender, not a dealer, and not an electrician. No pressure, ever. What follows is the plain-English rundown of panel sizing, wiring, and surge protection that buyers across Texas, Arkansas, Oklahoma, and Louisiana usually wish someone had explained before they picked a floor plan.

Electrical gets almost no airtime on a sales lot walkthrough. Buyers get shown cabinets, flooring, and countertops — not the panel in the utility closet. But the panel is what decides whether your home handles a second window unit, a shop welder, an RV hookup, or a backup generator without tripping a breaker every time two things run at once.

Key takeaways - 100-amp service is the HUD-code floor, 150-200 amp is the comfortable range for most modern single- and double-wide homes. - Aluminum branch wiring on older used homes is a real inspection flag — not automatically dangerous, but worth a licensed electrician's eyes before you close. - The meter base and service drop are often the buyer's responsibility, not the home's — ask who pays for the run from the pole before you budget setup costs. - Surge protection is cheap insurance against the voltage spikes that are common on rural co-op lines across the Ark-La-Tex. - A generator-ready setup is a planning decision, not a last-minute add — it changes panel choice and sub-panel placement.

How much electrical service your home actually needs

HUD code sets a minimum, but the minimum isn't always the right fit. A single-wide with electric range, water heater, and central AC can run comfortably on 100-amp service. A double-wide with an electric furnace, a second HVAC zone, a workshop, or an EV charger in the future usually wants 150 or 200 amp service instead.

The math that matters is simple: add up the big draws (range, water heater, dryer, HVAC) and leave headroom for anything you might add later — a hot tub, a shop, a generator transfer switch. Upsizing the panel at order time is inexpensive compared to upgrading it after the home is set and skirted.

Wiring type: copper, aluminum, and what to ask about

Most new manufactured homes ship with copper branch wiring throughout, which is the standard buyers should expect. Used homes built in the 1960s-1970s era sometimes used aluminum branch wiring, which has a documented history of loose-connection failure if it wasn't properly terminated with the right connectors and anti-oxidant compound.

Aluminum wiring by itself isn't a reason to walk away from an otherwise solid used home — it's a reason to have a licensed electrician check the connections, especially at outlets and switches, before you close. This is exactly the kind of item a pre-purchase inspection should flag; see our manufactured home inspection checklist for the full walkthrough.

The meter base, service drop, and who pays for what

Here's a detail that surprises a lot of first-time buyers: the home itself usually comes wired internally, but the physical connection from the utility pole to your meter base — the service drop — is frequently a site-prep cost, not something bundled into the home's price. Depending on your lot and how far the pole sits from your planned setup location, that run can be a modest line item or a meaningful one.

Ask early: who is responsible for the meter base, the service drop, and the inspection that your local utility requires before they'll energize the home? Getting this answered before you sign avoids a surprise during delivery week.

Surge protection: cheap insurance for rural power

Rural electric co-ops across the Ark-La-Tex are reliable day to day, but voltage spikes from lightning, grid switching, and equipment faults are more common on long rural lines than on tight urban grids. A whole-home surge protector installed at the panel is a relatively small cost that protects the HVAC compressor, the water heater's electronics, and every appliance in the home from the spike that would otherwise take them out in one event.

If you're also planning solar down the road, see our manufactured home solar panel guide — panel capacity and surge protection both factor into that decision too.

Planning for a generator before you need one

If backup power is anywhere on your radar — and after a Texarkana-area ice storm, it usually is for someone — the panel decision at order time matters. A manual transfer switch or an interlock kit is far easier (and cheaper) to add when the panel is being installed than to retrofit later. Our generator backup power guide walks through sizing a generator to your home's actual draw.

What this means for your home search

Electrical capacity won't be the first thing a floor plan brochure shows you, but it's worth two or three direct questions before you commit: What amperage is standard on this model? Is the wiring copper? Who covers the service drop? None of those questions slow down a sale — they just make sure the home you pick keeps up with how you actually plan to use it.

HomeHaven doesn't sell homes or electrical upgrades, so we don't have a reason to steer you toward the pricier panel. We just want your matchmaker call to cover the stuff that actually affects your first year of ownership.

Frequently Asked Questions

Is 100-amp electrical service enough for a manufactured home?

For a smaller single-wide with gas or standard appliances, 100 amps often works. For most double-wides with electric heat, central air, and a full kitchen, 150-200 amp service gives you comfortable headroom without tripping breakers during heavy-use months.

Is aluminum wiring in a used manufactured home a dealbreaker?

Not automatically. Aluminum branch wiring was common in homes built decades ago and can be safe when properly terminated. It is a specific item a licensed electrician should check during inspection, not an automatic reason to pass on the home.

Who pays to connect the home to the power pole?

This varies by seller and by lot, so ask directly. The service drop from the utility pole to your meter base is frequently treated as a site-prep cost separate from the home's price — confirm this before you budget your total setup costs.

Do I need a whole-home surge protector?

It isn't required, but it's a low-cost way to protect your HVAC, water heater, and appliances from the voltage spikes that are more common on rural co-op power lines. Many buyers add one at the same time the panel is installed.

Can I add generator backup power after the home is already set up?

Yes, but it's simpler and less expensive to plan for a transfer switch or interlock kit while the panel is being installed rather than retrofitting it afterward. If backup power matters to you, mention it during your matchmaker call before you finalize a floor plan.


Ready to talk through your specific electrical needs with an actual plan, not a brochure? Take the free 2-Minute Haven Match quiz or book your free matchmaker call. Prefer to skip the form? Call or text us at (903) 205-3300 — no pressure, ever.

Manufactured Home Electrical Systems: What Buyers Should Know Before You Sign — HomeHaven